•The process of installing and adjusting the mold on the precision press is as follows:

1. Adjust the height of the punch slider according to the closing height of the die, so that when the slider is at the bottom dead center, the distance between the bottom plane and the work surface is greater than the closing height of the die.

• Second, first raise the slider to the top dead point, put the die into the punching table, then stop the slider at the bottom dead point, adjust the height of the slider so that its bottom plane touches the upper plane of the lower die seat, and then use the die The handle or screw tightens the lower die base on the punch slider.

3. Raise the slide block of the precision punch press by 3~5mm, start the punch press, idle stroke 1~2 times, stop the slide block at the bottom dead center, and fix the upper die seat.

•Four, the precision punching machine carries out the test punching, adjust the slider to the required height, and if the upper screen has a top rod, the stripping bolt should be adjusted to the required height.