1.The main attention is to improve the safety production education for employees, establish and improve the skills training system for high-risk work, often carry out safety knowledge education for employees, and standardize the qualification of post entry. The operation must strictly abide by the operation procedures of high-speed precision punch and carry out standardized work.

2. Implement the safety production obligations of all employees, improve the safety work and inspection on the production site, carry out the theme activities of self correction and mutual inspection of production teams, enhance the on-site inspection of management personnel, correct the illegal work behaviors, and carry out strict evaluation on the violation personnel.

3. Select special tools for feeding to prevent people's arms from extending into the die mouth area; improve the safety maintenance of the operation area of the high-speed precision punch press; install optical maintenance and other safety devices in the operation area to ensure that the hands are outside the risk die area during the downward travel of the slider, and separate the dangerous area from the hands of the operators.

4. Enhance the inspection, maintenance, maintenance of high-speed precision punch equipment, found mechanical equipment problems, immediately carry out maintenance

5. The safety measures are improved from the process procedure, and the double key operation is specified. The down stroke movement of the slider is connected with the restriction of both hands. The operator is forced to push the manipulator with both hands to move the slider downward, so as to prevent damage.

6. Considering the safety and reliability of the stamping die itself, the safe die which can reduce the dangerous area of die mouth is selected and the small stroke of slide block is set, so that the hand can not reach into the die mouth area When the operator is in the process of delivering, positioning, picking up or carrying out waste disposal, some part of the body enters the risk area and touches the moving part of the mold, which is clamped or ejected.