In the operation of precision punch press, the route of automatic precision punch press is based on the solid-state press received by two lifting oil cylinder mould support plates. The support plate required by aluminum die-casting die is installed in the mold. The mold of precision punch manufacturer is fixed on the upper module of paper. The precision punch press is continuously left from left to right or from right to material pipe at a certain rate.

According to the work of the motor driven moving pulley, the precision punch drives the belt drive pulley to rotate passively and actively, so as to promote the positive crankshaft pulley. According to the positive stamping driven by the reverse rotation crankshaft driven by the crankshaft gear, the dominant power of the crankshaft and the crankshaft rotate in the opposite direction at the same speed with the drive of four groups of cranks and connecting rods The shaft of the connecting rod 2 is movably connected by the lower part of the device of the sliding piece, while the reciprocating left and right sliding punches driven by the reciprocating motion of the four connecting rods at the lower part, the relative motion of the stamping sheet material in the upper die, the lower die and the die is formed.

The speed of the precision punch press is fixed to one end of the above-mentioned itself by light pressing the elastic sheet, while the other end is fixed on the sliding device. The offset direction of the further left slide rail refers to the movement that is not limited in the vertical direction, and the movement direction of the rear sliding part refers to the curve that the front cover is set, which is limited by 4 rollers, but the curve of the roller And relative to the wheel side of the sliding piece of the turnover device, the movement of sliding along the vertical direction is not limited. According to the effect of moving left and right in the vertical direction on the elastic plate and curved roller, the mutual effect of the four slide devices of the upper die high-speed punch and the positioning of the lower die are accurate.