As we all know, the high-speed punch brings us the convenience of mass production. At the same time, because the high-speed punch has the characteristics of high-speed and high-pressure, the staff must abide by certain safety regulations when using the high-speed punch for stamping and forming. How should we pay attention to these in the production of high-speed punch?

1. The production personnel of high-speed punch must learn and master the safety operation rules and carry out the safe operation according to the requirements;

2. It is necessary to install protective cover for the transmission parts exposed to the press. It is forbidden to test the machine without protective cover;

3. Before production, check whether the main fastening screws are loose, whether the clutch, control mechanism, automatic stop device and brake are normal, and whether the lubrication system is short of oil;

4. Install the mold, open the slider to the bottom dead center, ensure the correct closing height, and ensure that the mold is firmly fastened;

5. Before working, idle run for 2-3 minutes to confirm the normal operation of high-speed punch;

6. The operator shall pay attention to the operation, and it is forbidden to put the tools or reach into the dangerous area directly;

7. In case of abnormal operation or abnormal sound of punch, the feeding should be stopped, and the causes should be checked and handled in time;

8. When punching a workpiece, hands or feet leave the button or pedal to prevent misoperation;

9. After the work, the mold is placed against, the power is disconnected and the environment is cleaned.